Jun
2020

How to Clean a Compressor Before or After EQ

It is very important to know how to clean a compressor before or after eq. Most people who buy new compressors will only clean the outside parts of the compressor and never use the most important part of a compressor. These parts are those that supply air to the entire compressor system. The majority of compressor problems can be attributed to having not cleaned the interior parts of the compressor well enough.

Evaporator. The evaporation of the air from the gas or liquid is the work of the evaporator. As the water in the fluid evaporates it will cool and settle on the walls of the evaporator. If the walls are cold it will collect moisture and condense to the gas in the fluid that is the result of the evaporator. A dirty evaporation system can cause an unnecessary loss of gas due to a larger than normal flow rate. Too much of the gas is collected in the system resulting in the loss of needed gas, overheating and if the system is overworked it may cause damage to the gas as well. To avoid this type of problem, you should ensure that the inside of the evaporation system is clean and free of bacteria and debris.

These systems can also be identified by the turn valve and also a small leak around the turn valve. The leak could cause the safe to open when no oil or gas is in the system. This cause the gas to ignite resulting in an explosion or fire. The safety stops should be inspected and cleaned as part of the regular maintenance of your compressor. If your compressor has an electric motor the power supply to the motor can break. When the power is cut to the motor safety shut off will automatically take place. The next day when you use the pump it will not run.