Apr
2020

How to Start Your Gas Condensing Unit?

Is your gas condensing unit turns off without the use of the ignition key? If so, then you need to use the ignition key again in order to start the unit. If the ignition key is not available, or if you can’t find it after pulling over, then you need to turn off the ignition and look for the ignition key on the steering wheel or anywhere in your vehicle. After locating the ignition key, then you need to use the ignition key again in order to start the unit. After replacing the ignition key and starting the unit, the condensing unit should be able to start up properly. This should be done whenever you are concerned about your gas condensing unit and engine starting issues.

Sometimes the gas condensing unit will turn on and then won’t even move at all, when you attempt to use the ignition key to start the unit. This usually happens when a home electrical system has an improper grounding. The condensing unit may malfunction due to a wiring problem within the interior of the unit. Sometimes the unit will just shut down or will not work at all. These are very common issues that occur when the unit does not have proper electrical connections. A common cause of this problem is when a headlight has a crack, which allows the ground to develop between the circuit board of the condensing unit and the motor. Also, improperly installed wiring inside the condensing unit can cause a similar problem.

Sometimes the motor of the condensing unit will stop working properly or the fuel filters will clog up with debris. If these problems happen, then it is recommended that you replace the old filter, since that may solve the problem of the condensing unit not turning on. If the unit is working properly and the problem is in the wires or within the motor, then you will have to get the wires replaced. If you have a regular heating and air conditioning unit in your vehicle, then it is recommended that you get it checked out by a professional in order to determine if there is a structural problem or if the problem is in the condensing unit.